Clamp-Style Pipe Connectors – Straight and Reducer Options

Description

Clamp-Style Pipe Connectors – Straight and Reducer Options

These black clamp-style pipe connectors are available in straight and reducer configurations. The product photograph shows a straight connector with two metal hose clamps. Select the connector by both pipe interfaces and the required connection height, rather than treating every similarly named size as the same part.

Choose the connection size

Straight selection codes include OD40/ID32/H90, OD60/ID50/H90, and OD120/ID110/H70. A reducer option is recorded as OD100/ID90 to OD75/ID65, H100. Confirm the measurement units and the meaning of each dimension before placing an order. Options with an incomplete end dimension require clarification.

Installation details to confirm

Measure both pipe interfaces and check the available axial space. Confirm the connector material, the required clamp arrangement, and whether clamps are included with the selected option. Share the conveyed medium, operating temperature, and pressure requirements so the offered configuration can be checked against your application. A dimensional match alone does not establish suitability for every fluid or operating condition.

Frequently asked questions

Can I order by nominal pipe size alone? Include the measured interface dimensions as well. Nominal size does not replace a check of the connector and pipe geometry.

Does the photograph show the exact order quantity? Confirm the quantity and included hardware for your selected option before ordering.

Request the right connector

Send the required size combination, quantity, and a photo or sketch of the existing joint. For a reducer, identify both ends clearly and include the available connection height. IKSONIC can use these details to clarify the configuration you need.

For clamp-style pipe connectors, contact IKSONIC with your connection details.