Custom Spring-Energized Seals

Description

Custom Spring-Energized Seals

IKSONIC custom spring-energized seals are offered through model and specification enquiries. The seal form shown combines an annular seal body with an internal spring element. Select the profile, dimensions and material together as a complete configuration, whether you are identifying a replacement or working from a new assembly drawing.

Material enquiries can address PEEK, PTFE or fluoroelastomer as separate requested configurations. These material names do not describe a single universal compound, and the same appearance does not establish that different seals use the same material. Include the required material and grade with your model or drawing reference so the proposed configuration can be identified clearly.

Enquiry options

Choose the enquiry route that best matches the information you have. These are consultation choices rather than fixed dimensional variants. Confirm the model, configuration and quantity before ordering.

Product and configuration reference

Identify the seal and its installation space

A ring diameter alone does not define a spring-energized seal. Include the inside diameter, outside diameter and axial width or height, and label the features being measured. If a drawing uses a different convention, retain its dimension labels and units rather than rearranging them into an unexplained size code.

The seal section and the surrounding installation space should be considered together. Provide the groove or housing details and the mating component dimensions when they are available. A cross-sectional sketch is particularly useful for showing which surface the seal contacts, where the spring sits and how the seal is oriented in the assembly.

For replacement identification, photograph both faces and the side profile in addition to recording dimensions. Note whether the measurements were taken from an unused sample or a removed part. An existing seal may have changed shape in service, so distinguish measured values from the original nominal dimensions when you have both.

Keep material enquiries distinct

For a PEEK enquiry, identify the required PEEK specification and the component or seal section to which it applies. For a PTFE enquiry, include any specified compound or filler requirements. For a fluoroelastomer enquiry, provide the required compound designation or existing part specification if known. Do not substitute one material family for another on the basis of colour or a similar ring shape.

If the assembly drawing controls the spring as well as the seal body, include both requirements. A photograph can help identify the visible arrangement, but it does not replace a material specification or a dimensioned section. Keep each requested material and profile under a separate part reference when comparing configurations.

Details for a complete quotation enquiry

The product photographs show seal examples and viewing angles, not a dimensioned selection chart or a mixed-size package. The required model, material and quantity should be recorded in the enquiry rather than inferred from the number or colour of the rings pictured.

Discuss your seal configuration

Contact IKSONIC with your model reference or drawing, dimensions and quantity. If you need help identifying an existing seal, include its measured size and clear profile photographs. The standard-model, custom-model and model-reference enquiry routes all begin with the information needed to define the requested part.